December 01, 2022
The temperature has dropped sharply in recent days.,But it's not time for the Excavators to stop working.。How to maintain the Excavator in winter,Here are a few ways,Keep your Excavator safe over the winter。
01
Start the excavator and preheat it.
Fully preheat the excavator before starting.,In order to avoid machine wear caused by low temperature.。Turn the fuel control dial to the low speed position;Start switch key remains in the preheat position;After the engine is started,If the oil pressure monitor indicator is on,Travel pedal and control lever cannot be operated。
02
Use suitable diesel fuel
Due to the decrease in temperature,Diesel viscosity increases,Liquidity becomes poor,It is easy to cause the decline of power and economic performance of diesel engine.。Therefore, it is better to choose diesel oil with lower freezing point in winter.。Wax temperature 4°CLeft and right,Select 0#Diesel;Wax temperature-6°CLeft and right,Choose-10#Diesel;Wax temperature-14°CLeft and right,Choose-20#Diesel;Wax temperature-31°CLeft and right,Choose-35#Diesel。
03
Timely oil replacement and maintenance
While replacing the diesel oil,The oil should also be changed.。In the northeast and other alpine regions.,In winter, it is necessary to consider replacing the oil with a higher grade.,In some areas of severe cold,Special antifreeze oil will also be used.,And when changing the oil.,Don't forget to replace and clean the oil filter.。
04
Maintain the battery in time
Pay special attention to the maintenance of the battery in winter,Low temperature will reduce the capacity of the battery,Measures should be taken to keep the battery warm.,Cover the battery with quilts and other clothes to keep warm.,Or remove from the machine,Place in a warm environment,Put it on the next day.。
05
Add antifreeze in time
Check the proportion of antifreeze in the coolant in time.,Make sure that the freezing point is below the local minimum temperatures,If the conditions are not met, please add antifreeze in time.。
China Forestry Machinery Pioneer It has 17 years of research and development of forestry machinery、Manufacturing experience Guangxi Xuwo Engineering Machinery Co., Ltd. Will be on November 26.-29 Shanghai BMW showE4-579 Wonderful appear
November thirteenth,Accompanied by Vice General Manager Li Yongjie, the delegation of Zhongke Xinji Engineering Technology Co., Ltd. visited Fangyuan Group.。 Guests go deep into the production line of Fangyuan Group,Observe the production
Danasen is the world leader in hydraulic power conversion equipment,You are invited to attend from November 26 to 29, 2024,Held at Shanghai New International Expo Center BAUMA CHINA (Shanghai BMW Construction Machinery Exhibition)。 This exhibi
November thirteenth,Chairman-in-Office of Sany Group、President Tang Xiuguo led the team to Kunming, Yunnan,Visit to Yunnan Jiantou Group,Secretary of the Party Committee of the Group、Chairman Chen Zujun and his delegation held a discussion.。The two sid
Copyright Notice 2002-2024 global-ce.com Construction Machinery Online. All rights reserved.
Address: Room 901, Building C, Ruipu Mansion, Hongjunying South Road No.15, Chaoyang District, Beijing.100107 P.R.China